Maintenance of diamond saw blade:
When the diamond saw blade is used up, the blank steel saw should be protected, handled with care, and cut off, because the diamond saw blade substrate can be reused for many times, and if the steel blank saw is deformed, it will be difficult to brazed well of new diamond segments on.
Maintenance of diamond grinding wheel:
1. The inner diameter correction of diamond grinding wheel and positioning hole processing must be carried out by the manufacturer. If the processing is poor, it will affect the use effect of the product and may cause danger. In principle, the reaming should not exceed the original hole diameter by 20mm to avoid affecting the stress balance.
2. When the diamond grinding wheel is no longer sharp and the cutting surface is rough, it must be reground in time. Grinding cannot change the original angle and destroy the dynamic balance.
Post time: Mar-13-2023